Changes to Step #11
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| - | [title] |
|---|---|
| + | [title] Y axis assembly |
| [* 5] Take the remaining 331mm* extrusion. (*The middle length of the four remaining extrusions) | |
| [* 1] Prepare the following parts: | |
| [* 6] 2x M5x10 screws. | |
| [* 2] 2x t-nuts. Slide them into the 331mm extrusion as shown in the picture. | |
| [* 7] Attach the 331mm extrusion, to the assembly, with the M5 screws. Do not fully tighten them yet! |