Changes to Step #8

Edit by Grégoire Saunier —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

-[* 9] Take your time for this step, it will be a reference for the rest of the assembly. Ask the help of someone else if you feel the need of having a third hand.
+[* 9] Take your time for this step, it will be a reference for the rest of the assembly. Ask the help of someone else if you feel the need of a third hand.
[* 2] Make sure you are on a flat and plane surface.
[* 7] Place the assembly vertically.
[* 9] Be careful to not let fall down the assembly.
[* 4] Square the extrusions with a square.
[* 5] Apply pressure in the directions shown and tighten strongly the two M5x10 screws.
[* 10] This step can be easier if you have a clamp. You can then clamp the thicker side of your square to the vertical extrusion as shown in the 3rd image.
[* 1] Verify that the assembly is still square after tightening.