Changes to Step #8
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
+ | [title] XY base assembly |
---|---|
[* 9] Take your time for this step, it will be a reference for the rest of the assembly. Ask the help of someone else if you feel the need of a third hand. | |
[* 2] Make sure you are on a flat and plane surface. | |
[* 3] Place the assembly vertically. | |
[* 9] Be careful to not let fall down the assembly. | |
[* 5] Square the extrusions with a square. | |
[* 7] Apply pressure in the directions shown and tighten strongly the two M5x10 screws. | |
[* 6] This step can be easier if you have a clamp. You can then secure the thicker side of your square to the vertical extrusion as shown in the 3rd image. | |
[* 1] Verify that the assembly is still square after tightening. |