Changes to Step #8

Edit by Dave Ogles —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Reference corner squaring
-[* 9] Take your time for this step, it will be a reference for the rest of the assembly. Ask the help of someone else if you feel the need of a third hand.
-[* 2] Make sure you are on a flat and plane surface.
-[* 3] Place the assembly vertically.
- [* 9] Be careful to not let fall down the assembly.
-[* 5] Square the extrusions with a square.
-[* 7] Apply pressure in the directions shown and tighten strongly the two M5x10 screws.
- [* 8] Tech tip: This step can be easier if you have a clamp. You can then secure the thicker side of your square to the vertical extrusion as shown in the 3rd image.
+[* 9] Take your time with this step. It will be a reference for the rest of the assembly. A third hand is useful at this step, ask someone to help, if possible.
+[* 2] Make sure that you are working on a flat and level surface.
+[* 3] Place the assembly vertically, as shown.
+ [* 9] Take care that the assembly does not fall.
+[* 5] Using a machinist's precision square, ensure that the two extrusions are perpendicular to each other.
+[* 7] Apply pressure in the directions shown and fully tighten the two M5x10 screws.
+ [* 8] Tech tip: This step can be made easier if you have a clamp. You can then secure the thicker side of your square to the vertical extrusion as shown in the 3rd image.
[* 9] Verify that the assembly is still square after tightening. Correct it if needed.