Changes to Step #8

Edit by Grégoire Saunier —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Reference corner squaring
-[* 9] Take your time with this step. It will be a reference for the rest of the assembly. A third hand is useful at this step, ask someone to help, if possible.
+[* 9] Take your time with this step. It will be a reference for the rest of the assembly. A third hand might be useful, ask someone to help, if possible.
[* 2] Make sure that you are working on a flat and level surface.
[* 3] Place the assembly vertically, as shown.
[* 9] Take care that the assembly does not fall.
[* 5] Using a machinist's precision square, ensure that the two extrusions are perpendicular to each other.
[* 7] Apply pressure in the directions shown and fully tighten the two M5x10 screws.
[* 8] Tech tip: This step can be made easier if you have a clamp. You can then secure the thicker side of your square to the vertical extrusion as shown in the 3rd image.
[* 9] Verify that the assembly is still square after tightening. Correct it if needed.