Changes to Step #12
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| + | [title] Squaring the base |
|---|---|
| [* 9] Take your time with this step. | |
| [* 3] Take one the smallest extrusions on the pile of not used yet. It is 290mm long. It will be used for reference. | |
| [* 7] Place the assembly at the end of a table | |
| [* 5] Carefully insert the 290mm extrusion in between as shown in the 2nd image. | |
| [* 9] Be gentle with the 290mm extrusion or you might mark permanently the assembled extrusions. | |
| [* 2] Apply pressure in the directions shown and tighten the two M5x10 screws. To not overtighten them for now, only firmly secure the extrusion. movement of the extrusion. | |
| [* 1] You can now remove the 290mm extrusion carefully and reserve it for later. |