Changes to Step #12

Edit by Grégoire Saunier —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] XY base squaring
[* 9] Take your time with this step.
-[* 3] Take one the smallest extrusions on the pile of not used yet. It is 290mm long. It will be used for reference.
-[* 7] Place the assembly at the end of a table
+[* 3] Take one the smallest extrusions on the pile of unused. It is 290mm long. It will be used for reference.
+[* 7] Place the assembly at the end of a table.
[* 5] Carefully insert the 290mm extrusion in between as shown in the 2nd image.
- [* 9] Be gentle with the 290mm extrusion or you might mark permanently the assembled extrusions.
-[* 2] Apply pressure in the directions shown and tighten the two M5x10 screws. To not overtighten them for now, only firmly secure the extrusion. movement of the extrusion.
-[* 1] You can now remove the 290mm extrusion carefully and reserve it for later.
+ [* 9] Be gentle or you might mark permanently the assembled extrusions.
+[* 2] Apply pressure in the directions shown and tighten the 2x M5x10 screws strongly.
+[* 1] Remove carefully the 290mm extrusion carefully and reserve it for later.