Changes to Step #12
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| - | [title] |
|---|---|
| + | [title] Y axis squaring |
| [* 9] Take your time with this step. | |
| [* 3] Take the smallest extrusions of those remaining. It is 290mm long. It will be used as a reference, to ensure that parts are correctly spaced. | |
| [* 7] Place the assembly at the end of a table, as shown, so that the two 331mm extrusions lie flat on the surface. | |
| [* 5] Carefully place the 290mm extrusion between the other extrusions, as shown in the 2nd image. | |
| [* 9] Be careful that you do not scratch or permanently mark the extrusions whilst doing this. | |
| [* 2] Apply pressure in the directions shown and fully tighten the 2x M5x10 screws. | |
| [* 1] Carefully remove the 290mm extrusion and reserve it for later. |