Changes to Step #14

Edit by Grégoire Saunier —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Install t-nuts for Z axis
-[* 7] Prepare 12x t-nuts and test them individually with an M5 screw. This is a little tip to avoid having to redo all the hard work of squaring the frame if a t-nut is defective. You can thanks [https://www.youtube.com/channel/UC2Tc0TsvFxC83zF1w5x1PWQ|3DMN for this handy tip :)]
+[* 7] Take 12 of the previously tested t-nuts. They will be inserted on both 20mm sides of the vslots.
[* 2] Inserts 3x t-nuts on each side (12x in total) as seen on the 2nd and 3rd picture.