Changes to Step #16
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| - | [title] |
|---|---|
| + | [title] XY base assembly |
| [* 7] Flip the assembly. Be careful to not loose any t-nuts! | |
| [* 5] Take 4x t-nuts and slide them as seen on the 1st picture. | |
| [* 2] With 4x M5x10, assemble the second 370mm extrusion + plate assembly you have prepared in the beginning of this chapter. | |
| [* 2] Do not tighten them fully yet! | |
| [* 6] Verify you still have the 12 t-nuts inserted on the side of the extrusions. |