Changes to Step #16

Edit by Grégoire Saunier —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

-[title] XY base assembly
+[title] Y axis assembly
[* 7] Flip the assembly. Being careful that the placed t-nuts do no fall out.
[* 5] Take 4x t-nuts and insert them as shown in the 1st picture.
[* 2] Take the second 370mm extrusion + plate assembly which you built in step 5. Attach it with 4x M5x10 screws. Do not tighten them fully yet!
[* 6] Verify that all 12 t-nuts remain in the sides of the 331mm extrusions.