Changes to Step #17

Edit by Dave Ogles —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] XY base squaring
-[* 9] Take your time with this step. Ask the help of someone else if you feel the need of having a third hand (please don't use one of your foot :) ).
-[* 7] Move the XY base in vertical position with the 3D printed foot on the bottom left.
- [* 9] Be careful to not let fall down the XY base.
-[* 2] Make sure you are on a flat and plane surface.
-[* 5] Apply pressure in the directions shown and tighten strongly the 2x M5x10 screws.
+[* 9] Take your time with this step. Ask for help from someone else if you feel the need of a third hand (please don't use one of your feet :) ).
+[* 7] Move the XY base in to the vertical position with the 3D printed foot on the bottom left.
+ [* 9] Take care that the XY base does not fall over.
+[* 2] Make sure you are on a flat and level surface.
+[* 5] Apply pressure in the directions shown and fully tighten the 2x M5x10 screws.