Changes to Step #17
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| - | [title] |
|---|---|
| + | [title] Y axis squaring |
| [* 9] Take your time with this step. Ask for help from someone else if you feel the need of a third hand (please don't use one of your feet :) ). | |
| [* 7] Move the XY base in to the vertical position with the 3D printed foot on the bottom left. | |
| [* 9] Take care that the XY base does not fall over. | |
| [* 2] Make sure you are on a flat and level surface. | |
| [* 5] Apply pressure in the directions shown and fully tighten the 2x M5x10 screws. |