Changes to Step #17

Edit by Grégoire Saunier —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Y axis squaring
[* 9] Take your time with this step. Ask for help from someone else if you feel the need of a third hand (please don't use one of your feet :) ).
-[* 7] Move the XY base in to the vertical position with the 3D printed foot on the bottom left.
+[* 7] Move the Y axis into to the vertical position with the 3D printed foot on the bottom left.
[* 9] Take care that the XY base does not fall over.
[* 2] Make sure you are on a flat and level surface.
[* 5] Apply pressure in the directions shown and fully tighten the 2x M5x10 screws.