Changes to Step #18

Edit by Grégoire Saunier —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

+[title] Finish XY base assembly
[* 9] Take your time with this step. It is the last squaring operation for the base of the frame.
[* 7] Move down the assembly with and position the 3D printed foot on the left and back.
-[* 2] Carefully insert the 290mm extrusion in between as shown in the 2nd image.
+[* 2] Carefully insert the 290mm extrusion in between as shown in the 1st image.
[* 5] Apply pressure as shown in the image and tighten the M5 screw strongly.