Changes to Step #18
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| [title] Finish XY base assembly | |
| [* 9] Take your time with this step. It is the last squaring operation for the base of the frame. | |
| [* 7] Move down the assembly with and position the 3D printed foot on the left and back. | |
| [* 2] Carefully insert the 290mm extrusion in between as shown in the 1st image. | |
| - | [* 9] Be gentle with the 290mm extrusion or you might mark permanently the assembled extrusions. |
| + | [* 9] Be gentle with the 290mm extrusion or you might mark permanently the assembled extrusions. |
| [* 5] Apply pressure as shown in the image and tighten the M5 screw strongly. |