Changes to Step #18
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| - | [title] |
|---|---|
| + | [title] Y axis squaring |
| [* 9] Take your time with this step. It is the last squaring operation for the XY base :). | |
| [* 7] Move down the assembly with and position the 3D printed foot on the left and back. | |
| [* 2] Carefully insert the 290mm extrusion in between as shown in the 1st image. | |
| [* 9] Be gentle or you might mark permanently the extrusions. | |
| [* 5] Apply pressure as shown in the image and tighten the M5 screw strongly. |