Changes to Step #18

Edit by Grégoire Saunier —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Y axis squaring
-[* 9] Take your time with this step. It is the last squaring operation for the XY base :).
+[* 9] Take your time with this step. It is the last squaring operation for the Y axis :).
[* 7] Move down the assembly with and position the 3D printed foot on the left and back.
[* 2] Carefully insert the 290mm extrusion in between as shown in the 1st image.
[* 9] Be gentle or you might mark permanently the extrusions.
[* 5] Apply pressure as shown in the image and tighten the M5 screw strongly.