Changes to Step #13

Edit by Dave Ogles —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] T-nuts and extrusions verifications
-[* 5] Take 16x t-nuts and test them individually with an M5 screw.
- [* 10] Those 16 t-nuts will require to disassemble the base of the frame in case one is defective. It is then better to verify them first. You can thanks [https://www.youtube.com/channel/UC2Tc0TsvFxC83zF1w5x1PWQ|3DMN for this handy tip :)]
-[* 1] Double check you have used the correct extrusion lengths:
+[* 5] Take 16x t-nuts and for each, check that the threads are clear by inserting an M5 screw.
+ [* 10] Those 16 t-nuts are captive and would require you to disassemble the base of the frame, if you later find any to be defective. It is easier to check them first. You can thanks [https://www.youtube.com/channel/UC2Tc0TsvFxC83zF1w5x1PWQ|3DMN for this handy tip :)]
+[* 1] Double check that you have used the correct extrusion lengths:
[* 7] 370mm
[* 3] 331mm