Changes to Step #15
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| + | [* 7] Flip the assembly. Be careful to not loose any t-nuts! |
|---|---|
| + | [* 2] Take the last 4 t-nuts you previously tested and slide them in the v-slots as shown on the image. |
| + | [* 5] Little tip: you can tape them with the center of the v-slots, this will avoid to loose them during the next steps. Do not tape them to the sides as we will need them as reference for squaring the assembly. |
Image 1
No previous image
Added
Image 2
No previous image
Added