Changes to Step #15
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| [title] T-nuts installation for angle corners | |
| [* 7] Flip the assembly. Be careful to not loose any t-nuts! | |
| [* 2] Take the last 4 t-nuts you previously tested and slide them in the extrusions as shown on the image. | |
| - | [* 5] Little tip: you can tape them with the center of the extrusions, this will avoid to loose them during the next steps. Do not tape them to the sides as we will need them as reference for squaring the assembly. |
| + | [* 5] Tech tip: you can tape the t-nuts with the center of the extrusions, this will avoid to loose them during the next steps. |
| + | [* 9] Do not place tape on the sides of the extrusions, only on the center. The sides will be used as a reference and the thickness of the tape could affect the quality of your squaring. |