Changes to Step #15

Edit by Dave Ogles —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] T-nuts installation for angle corners
-[* 7] Flip the assembly. Be careful to not loose any t-nuts!
-[* 2] Take the last 4 t-nuts you previously tested and slide them in the extrusions as shown on the image.
-[* 5] Tech tip: you can tape the t-nuts with the center of the extrusions, this will avoid to loose them during the next steps.
- [* 9] Do not place tape on the sides of the extrusions, only on the center. The sides will be used as a reference and the thickness of the tape could affect the quality of your squaring.
+[* 7] Flip the assembly. Being careful that the placed t-nuts do no fall out.
+[* 2] Take the remaining 4 t-nuts, which you previously tested, and slide them into the extrusions as shown in the image.
+[* 5] Tech tip: You can tape the t-nuts to the centre of the extrusions. This will prevent them sliding out of the extrusions during the following steps. (two small pieces of Blu Tack also work)
+ [* 9] Do not place tape on the outer, 20mm, faces of the extrusions. The sides will be placed flat on the table and the thickness of the tape could affect accuracy whilst squaring the frame.