Changes to Step #20
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| + | [* 1] Flip the assembly (yes again!). |
|---|---|
| + | [* 1] Prepare the following parts: |
| + | [* 7] 4x angle corners |
| + | [* 2] 4x t-nuts |
| + | [* 5] 8x M5x8mm screws |
| + | [* 4] Remove the tape of the 4 t-nuts and place them as shown on the image. |
| + | [* 6] Insert t-nuts on the vertical extrusions as shown on 2nd and 3rd image. |
Image 1
No previous image
Added
Image 2
No previous image
Added
Image 3
No previous image
Added