Changes to Step #20

Edit by Grégoire Saunier —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Angle corners assembly
[* 1] Flip the assembly (yes again!).
[* 1] Prepare the following parts:
[* 7] 4x angle corners
[* 2] 4x t-nuts
[* 5] 8x M5x8mm screws
-[* 4] Remove the tape of the 4 t-nuts and place them as shown on the image.
-[* 6] Insert t-nuts on the vertical extrusions as shown on 2nd and 3rd image.
+[* 4] Remove the tape of the 4 t-nuts and slide them close to the vertical extrusions.
+[* 6] Insert t-nuts on the vertical extrusions.