Changes to Step #21
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| + | [title] Angle corner assembly |
|---|---|
| [* 7] Assemble a black angle corner with 2x M5x8 screws to each corners. Do not tighten them yet! | |
| [* 5] For each corners, tighten alternatively the two M5x8 screws while applying pressure as shown on the images. | |
| - | [* 10] The angled corners might warp a little the frame while tightened, we will solve this in the next step. Applying pressure while tightening reduce this. |
| + | [* 10] The angled corners might twist a little the frame while tightened, we will solve this in the next step. Applying pressure while tightening reduce this. |
| + | [* 10] Tech note: this is why the Bear frame is not using angle corners in another place. |