Changes to Step #21

Edit by Grégoire Saunier —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Angle corner assembly
[* 7] Assemble a black angle corner with 2x M5x8 screws to each corners. Do not tighten them yet!
[* 5] For each corners, tighten alternatively the two M5x8 screws while applying pressure as shown on the images.
[* 10] The angled corners might twist a little the frame while tightened, we will solve this in the next step. Applying pressure while tightening reduce this.
- [* 10] Tech note: this is why the Bear frame is not using angle corners in another place.
+ [* 11] Tech note: this is why the Bear frame is not using angle corners in another place.