Changes to Step #21

Edit by Grégoire Saunier —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Angle corner assembly
-[* 7] Assemble a black angle corner with 2x M5x8 screws to each corners. Do not tighten them yet!
+[* 7] Assemble an angle corner with 2x M5x8 screws to each corners. Do not tighten them fully yet!
[* 5] For each corners, tighten alternatively the two M5x8 screws while applying pressure as shown on the images.
-[* 10] The angled corners might twist a little the frame while tightened, we will solve this in the next step. Applying pressure while tightening reduce this.
+[* 10] The angle corners might twist a little the frame during tightening, we will solve this in the next step. Applying pressure while tightening reduce this.
[* 11] Tech note: this is why the Bear frame is not using angle corners in another place.