Changes to Step #21

Edit by Dave Ogles —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Angle corner assembly
-[* 7] Assemble an angle corner with 2x M5x8 screws to each corners. Do not tighten them fully yet!
-[* 5] For each corners, tighten alternatively the two M5x8 screws while applying pressure as shown on the images.
-[* 10] The angle corners might twist a little the frame during tightening, we will solve this in the next step. Applying pressure while tightening reduce this.
- [* 11] Tech note: this is why the Bear frame is not using angle corners in another place.
+[* 7] Attach an angle corner, using 2x M5x8 screws at each corner. Do not tighten them fully yet!
+[* 5] For each corner, tighten the two M5x8 screws, in turn, while applying pressure as shown in the images.
+[* 10] The angle corners might pull the frame slightly out of alignment as you tighten them, we will correct this in the next step. Applying pressure, to hold them tight against the extrusions, while tightening the screws, helps to reduce this.
+ [* 11] Tech note: this is why the Bear frame does not use angle corners in other places.