Changes to Step #22
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| + | [title] Angle corner assembly |
|---|---|
| [* 2] Make sure you are on a flat and plane surface | |
| [* 7] Check that the frame is not twisted by pressing down on each corner. | |
| [* 7] If the frame remains flat you can continue to the next step. | |
| - | [* 5] If the frame is wobbling, place a 5-10mm thick object under the opposite corner (an old red printed part in our case). |
| + | [* 5] If the frame is wobbling, place a 5-10mm thick object under the opposite corner (an old red printed part in our case) as shown in the 2nd image. |
| [* 10] The little up-down green arrow shows the wobbly diagonal. It might be the other diagonal for you, in this case, place the object in the bottom right corner. | |
| [* 6] Apply pressure on the wobbly corners on both sides at the same time. No need to apply strong pressure. | |
| [* 1] Now remove the thick object and verify again that the frame remains flat. If it is still wobbling, repeat those steps until it remains flat. |