Changes to Step #22

Edit by Grégoire Saunier —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Angle corner assembly
[* 2] Make sure you are on a flat and plane surface
-[* 7] Check that the frame is not twisted by pressing down on each corner.
+[* 7] Check that the frame is not twisted by pressing on each corners one by one.
[* 7] If the frame remains flat you can continue to the next step.
- [* 5] If the frame is wobbling, place a 5-10mm thick object under the opposite corner (an old red printed part in our case) as shown in the 2nd image.
+ [* 5] If the frame is wobbling, place a 5-10mm thick object under the opposite corner as shown in the 2nd image.
[* 10] The little up-down green arrow shows the wobbly diagonal. It might be the other diagonal for you, in this case, place the object in the bottom right corner.
[* 6] Apply pressure on the wobbly corners on both sides at the same time. No need to apply strong pressure.
[* 1] Now remove the thick object and verify again that the frame remains flat. If it is still wobbling, repeat those steps until it remains flat.
+ [* 10] If this is still not working double check if your surface is flat. If this is the case then unscrew a little the angle corners and repeat previous step and then current one.