Changes to Step #22

Edit by Dave Ogles —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Angle corner assembly
-[* 2] Make sure you are on a flat and plane surface
-[* 7] Check that the frame is not twisted by pressing on each corners one by one.
- [* 7] If the frame remains flat you can continue to the next step.
- [* 5] If the frame is wobbling, place a 5-10mm thick object under the opposite corner as shown in the 2nd image.
- [* 10] The little up-down green arrow shows the wobbly diagonal. It might be the other diagonal for you, in this case, place the object in the bottom right corner.
- [* 6] Apply pressure on the wobbly corners on both sides at the same time. No need to apply strong pressure.
- [* 1] Now remove the thick object and verify again that the frame remains flat. If it is still wobbling, repeat those steps until it remains flat.
- [* 10] If this is still not working double check if your surface is flat. If this is the case then unscrew a little the angle corners and repeat previous step and then current one.
+[* 2] Make sure you are on a flat and level surface
+[* 7] Check that the frame is not twisted by pressing downwards, on each corner in turn.
+ [* 7] If the frame is flat and does not wobble, you can continue to the next step.
+ [* 5] If the frame wobbles, place a 5-10mm thick object under the opposite corner as shown in the 2nd image.
+ [* 10] The small green arrows show the wobbly diagonal. It might be the other diagonal for you, in this case, place the object in the bottom right corner.
+ [* 6] Apply pressure on the wobbly corners on both sides at the same time. There is n need to apply strong pressure.
+ [* 1] Now remove the thick object and check whether the frame is now flat on the table. If it is still wobbling, repeat these steps until it lies flat on the table.
+ [* 10] If the frame is still wobbling, double check that your surface is flat. If necessary, loosen all of the angle corners and repeat the previous step (Step 21) and then the current one.