Changes to Step #1
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| [* 1] Prepare the following hardware: | |
| [* 3] 1x 290mm extrusion | |
| [* 7] 1x 359mm extrusion | |
| [* 5] 2x joining plates | |
| [* 2] 2x M5x10 screws | |
| [* 6] 2x t-nuts. Slide them in a side of the 359mm extrusion as shown on the picture. | |
| - | [* 8] Attach the joining plate using the 3 M5x10 screws. Do not tighten them fully yet. |
| + | [* 8] Attach the joining plate using the 3 M5x10 screws on the longest extrusion. Do not tighten them fully yet. |