Changes to Step #1

Edit by Dave Ogles —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Left and right Z axis extrusions
-[* 1] Prepare the following hardware:
+[* 1] Gather the following hardware:
[* 3] 1x 290mm extrusion
[* 7] 1x 359mm extrusion
[* 5] 2x joining plates
[* 2] 2x M5x10 screws
- [* 6] 2x t-nuts. Slide them in a side of the 359mm extrusion as shown on the picture.
-[* 8] Attach the joining plate using the 2x M5x10 screws on the longest extrusion. Do not tighten them fully yet.
+ [* 6] 2x t-nuts. Slide them in one side of the 359mm extrusion as shown in the picture.
+[* 8] Attach the joining plate, using the 2x M5x10 screws, to the longest extrusion. Do not tighten them fully yet.