Changes to Step #2

Edit by Dave Ogles —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Left and right Z axis extrusions
-[* 3] Place vertically the 290mm extrusion at the end of the 359mm extrusion.
-[* 5] With the help of the second joining plate, press the plates as shown in the 2nd image and tighten the M5 screws strongly.
+[* 3] Hold the 290mm extrusion, vertically, against the end of the 359mm extrusion. We will use this to correctly align the joining plate.
+[* 5] With the help of the second joining plate, hold the plates as shown in the 2nd image. Ensure that the joining plate is flat on the table and flush with the 290mm extrusion before fully tightening the M5 screws.