Changes to Step #2
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| [title] Left and right Z axis extrusions | |
| - | [* 3] Hold the 290mm extrusion, vertically, against the end of the 359mm extrusion. We will use this to correctly align the joining plate. |
| + | [* 3] Hold the 290mm extrusion, vertically, against the end of the 359mm extrusion. |
| + | [* 10] We use the 290mm extrusion as a spacer to correctly set the position of the joining plate. |
| [* 5] With the help of the second joining plate, hold the plates as shown in the 2nd image. Ensure that the joining plate is flat on the table and flush with the 290mm extrusion before fully tightening the M5 screws. |