Changes to Step #3

Edit by Dave Ogles —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Left and right Z axis extrusions
[* 1] Prepare the following parts:
[* 3] 1x 290mm (same extrusion as previously).
- [* 7] 1x 359mm.
+ [* 7] 1x 359mm extrusion.
[* 5] 1x joining plates (in addition to the extra one left after the previous step).
[* 2] 2x M5x10 screws.
- [* 6] 2x t-nuts. Slide them in a side of the 359mm extrusion as shown on the picture.
+ [* 6] 2x t-nuts. Slide them in one side of the 359mm extrusion as shown in the picture.
[* 8] Repeat the previous step to build a 2nd mirrored extrusion + plate assembly.
-[* 9] Verify that both assemblies are mirrored and the extrusions have the same size (359mm).
+[* 9] Check that both assemblies are the mirror of each other and that the extrusions are the same length (359mm).