Changes to Step #4
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| + | [title] Top Z axis extrusion |
|---|---|
| [* 1] Prepare the following parts: | |
| [* 3] 1x 290mm | |
| [* 7] 1x build helper Z (''build_helper_z.stl'') | |
| [* 5] 3x joining plates | |
| [* 2] 2x M5x10 screws | |
| [* 6] 2x t-nuts. Slide them in a side of the 359mm extrusion as shown on the picture. | |
| [* 8] Attach one joining plate using the 2x M5x10 screws on the longest extrusion. Do not tighten them fully yet. |