Changes to Step #4

Edit by Dave Ogles —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Top Z axis extrusion
[* 1] Prepare the following parts:
[* 3] 1x 290mm
[* 7] 1x build helper Z (''build_helper_z.stl'')
[* 5] 3x joining plates
[* 2] 2x M5x10 screws
- [* 6] 2x t-nuts. Slide them in a side of the 359mm extrusion as shown on the picture.
-[* 8] Attach one joining plate using the 2x M5x10 screws on the longest extrusion. Do not tighten them fully yet.
+ [* 6] 2x t-nuts. Slide them in one side of the 290mm extrusion as shown in the picture.
+[* 8] Attach one joining plate using the 2x M5x10 screws to extrusion, as shown. Do not tighten them fully yet.