Changes to Step #7
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| + | [title] Z axis extrusions assembly |
|---|---|
| [* 1] Prepare the following parts: | |
| [* 7] 1x 359mm extrusion + plate assembly | |
| [* 3] 1x 290mm extrusion + plates assembly | |
| [* 5] 3x M5x10 screws | |
| [* 6] 3 t-nuts. Slide them in a side of the 359mm extrusion as shown on the picture. | |
| [* 7] Attach both assemblies together with 3x M5x10 screws. Do not tighten them fully yet. | |
| [* 2] With the help of a square, make sure you have a 90° angle and tighten strongly the 3x M5x10 screws. | |
| [* 9] Make sure the plates and extrusions are correctly oriented! |