Changes to Step #8
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| + | [title] Z axis extrusions assembly |
|---|---|
| [* 1] Prepare the following parts: | |
| [* 7] 1x 359mm extrusion + plate assembly | |
| [* 3] 1x assembly of the previous step | |
| [* 2] 3x M5x10 screws | |
| [* 6] 3x t-nuts. Slide them in the 359mm extrusion as shown on the picture. | |
| [* 5] Repeat the assembly of the previous step to form a correctly squared U. Make sure it is square. |