Changes to Step #8

Edit by Dave Ogles —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Z axis extrusions assembly
[* 1] Prepare the following parts:
[* 7] 1x 359mm extrusion + plate assembly
- [* 3] 1x assembly of the previous step
+ [* 3] 1x assembly from the previous step.
[* 2] 3x M5x10 screws
- [* 6] 3x t-nuts. Slide them in the 359mm extrusion as shown on the picture.
-[* 5] Repeat the assembly of the previous step to form a correctly squared U. Make sure it is square.
+ [* 6] 3x t-nuts. Slide them in the 359mm extrusion as shown in the picture.
+[* 5] Repeat the instructions from the previous step to form a correctly squared U (Z axis). Make sure it is square and flat.