Changes to Step #11
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| + | [title] Z axis assembly |
|---|---|
| [* 2] Place the Z axis on the XY base as shown on the 1st image. Place the Z axis a little on the back (we will set the correct distance in a later step). | |
| [* 9] Be careful to not let the Z axis falling down! | |
| [* 5] Verify the orientation of the plates, they should face be on the shorter distance size. | |
| [* 7] Secure the Z axis with 3x M5x10 screws. Do not tighten them fully yet. |