Changes to Step #11

Edit by Grégoire Saunier —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Z axis assembly
-[* 2] Place the Z axis on the XY base as shown on the 1st image. Place the Z axis a little on the back (we will set the correct distance in a later step).
+[* 2] Place the Z axis on the Y axis as shown on the 1st image. Place the Z axis a little on the back (we will set the correct distance in a later step).
[* 9] Be careful to not let the Z axis falling down!
[* 5] Verify the orientation of the plates, they should face be on the shorter distance size.
[* 7] Secure the Z axis with 3x M5x10 screws. Do not tighten them fully yet.