Changes to Step #11

Edit by Dave Ogles —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Z axis assembly
-[* 2] Place the Z axis on the Y axis as shown on the 1st image. Place the Z axis a little on the back (we will set the correct distance in a later step).
- [* 9] Be careful to not let the Z axis falling down!
-[* 5] Verify the orientation of the plates, they should face be on the shorter distance size.
-[* 7] Secure the Z axis with 3x M5x10 screws. Do not tighten them fully yet.
+[* 2] Place the Z axis on the Y axis as shown on the 1st image. Place the Z axis a little closer towards the back of the frame (we will set the correct distance in a later step).
+ [* 9] Take care to ensure that the Z axis does not fall down!
+[* 5] Check the orientation of the Z axis. The joining plates should be pointing towards the back of the frame, as shown.
+[* 7] Secure the Z axis with 3x M5x10 screws. Do not fully tighten them yet.