Changes to Step #13
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| + | [title] Z axis squaring |
|---|---|
| [* 9] Take your time with this step. | |
| [* 2] Place the ''build_helper_z'' to set the distance from the back of the frame. | |
| [* 5] Add your square to the assembly and push it in the direction of the ''build_helper_z''. | |
| [* 7] Tighten strongly the 3x M5x10 screws. | |
| [* 6] This step can be easier if you have a clamp. You can then secure the thicker side of your square to the bottom extrusion as shown in the 3rd image. | |
| [* 8] As your clamp might be thick, put the frame on thick part (we use the ''psu_upper_mount'' in our case) | |
| [* 9] Verify the Z axis is at 90° and repeat this step if necessary | |
| [* 9] Verify that the plates and extrusions are correctly oriented. |