Changes to Step #16
Edit by Grégoire Saunier —
Edit approved by Grégoire Saunier
- Before
- After
- Unchanged
Step Lines
| + | [title] Z axis final assembly |
|---|---|
| [* 7] Attach a joining plate with 5x M5x10 screws. Do not tighten them fully yet. | |
| [* 5] Use the ''build_helper_z'' to align the plate with the extrusion. Tighten the two M5 screws strongly. | |
| [* 2] Verify your plate is correctly aligned with both extrusions. | |
| [* 9] If the plates are not perfectly aligned with the Z axis extrusion it might cause an issue with the Z motor mount later. |