Changes to Step #16

Edit by Dave Ogles —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Z axis final assembly
[* 7] Attach a joining plate with 5x M5x10 screws. Do not tighten them fully yet.
-[* 5] Use the ''build_helper_z'' to align the plate with the extrusion. Tighten the two M5 screws strongly.
+[* 5] Use the ''build_helper_z'' to align the plate with the extrusion. Fully tighten the five M5 screws.
[* 2] Verify your plate is correctly aligned with both extrusions.
[* 9] If the plates are not perfectly aligned with the Z axis extrusion it might cause an issue with the Z motor mount later.