Changes to Step #17

Edit by Grégoire Saunier —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[* 7] Put the frame on its other side.
-[* 5] Attach a joining plate as explained in the previous step with 5x M5x10 screws and the help of ''build_helper_z''. Fully tighten the 5 screws.
+[* 5] Repeat the previous step on this side
[* 2] Verify your plate is correctly aligned with both extrusions.
[* 9] If the plates are not perfectly aligned with the Z axis extrusion it might cause an issue with the Z motor mount later.