Changes to Step #1

Edit by Grégoire Saunier —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

-[title] Add t-nuts for Y axis printed parts
+[title] Install Y rod holders
[* 3] Slide 6x t-nuts in top of the front extrusion.
[* 7] Slide 5x t-nuts in top of the back extrusion.
[* 5] Assemble 4x ''y_rod_holders'' with 8x M5x12 screws. Tighten them to avoid sliding, we will set the correct position later.
[* 2] Verify you have used the correct t-nuts. You should have 2x free t-nuts in the middle of front and 1x free in the middle of the back.