Changes to Step #1

Edit by Dave Ogles —

Edit approved by Grégoire Saunier

Before
After
Unchanged

Step Lines

[title] Install Y rod holders
-[* 3] Slide 6x t-nuts in the top of the front extrusion.
-[* 7] Slide 5x t-nuts in the top of the rear extrusion.
+[* 3] Slide 6x t-nuts in the top channel of the front extrusion.
+[* 7] Slide 5x t-nuts in the top channel of the rear extrusion.
[* 5] Attach 4x ''y_rod_holders'' to the frame, using 8x M5x12 screws, as shown. Tighten them just enough to prevent sliding, we will set the correct position later.
[* 2] Check that you have have 2x free t-nuts in the top middle of the front extrusion and 1x free t-nut in the top middle of the rear extrusion.